Adsorption dryer drying compressed air pressure swing adsorption principle

Modular adsorption dryer, also known as modular adsorption dryer, referred to as modular suction dryer. The dryer is used to compress air drying, modular design will be the original large volume, heavy weight equipment to improve the size and light weight, if the later need to expand the equipment, do not have to replace the whole set, can directly add modules on the equipment, simple and convenient, can be installed in the factory interior. Conventional twin-tower dryers waste a lot of energy, but the SR modular dryer solves this problem with an internal dew point meter and ES energy-saving features.

The working principle of the adsorption dryer should be clear to everyone, simply put, one tower adsorption drying, another tower reduced pressure regeneration. Timing control, as the name suggests, is to control drying and regeneration according to time. Since the general gas consumption is unstable and has a certain degree of fluctuation, if the drying and regeneration of the dryer is controlled by traditional timing, a large amount of regeneration gas will be wasted.

So how does the dew point control switch? The switching time of the double cylinder of the adsorption dryer will be switched according to the actual dew point demand, and the compressed air consumed by the adsorbent regeneration will be automatically turned off by the controller after the regeneration is completed, which reduces the waste of a large amount of regeneration gas and improves the working efficiency of the suction dryer.

Modular adsorption dryer not only energy saving, but also optimized in model, size, weight, in order to meet the needs of different industries, designed a number of series, the model table is as follows, the technical parameters are a little complicated, if you don't understand the place can be at any time Ska purification company

Adsorption dryer drying compressed air pressure swing adsorption principle

分享至微信分享

分享至微信

分享至微信